The rocker switch plays the same role as a general switch in disconnecting and connecting the circuit.

During installation, there are two opening clips on both sides of the rocker switch.  Align the switch with the holes on the board and push down, waiting for the clips to secure the switch to the board.

When wiring, the spring insertion method is commonly used, in which a pressed spring is directly inserted into the pins of the rocker switch.  This method is ideal for maintenance and is commonly used in high-volume production. The disadvantage is that poor contact can easily occur over time.

You can also use welding methods.  When using welding methods, be sure to cover the line with a heat-shrink tube before welding.  After welding, replace the heat-shrink tube at the welding position for insulation! (This step is very important to avoid arcing and abnormal short circuits!)